John-wood SpaceSaver (2.5 Gallon) Bedienungsanleitung

1Residential ElectricWater HeaterInstallation Instructions and Use & Care GuideTo obtain technical, warranty or service assistance during or after

10NOTE: During low demand periods when hot water is not being used, a lower thermostat setting will reduce energy losses and may satisfy your normal h

11MAINTENANCE OF YOUR WATER HEATERTemperature and PressureRelief ValveManually operate the temperature and pressure relief valve at least once a year

12Removing the Front Panel1. Disconnect the electrical power and follow “Draining and Flushing Instructions”.2. Remove the temperature knob by pulli

13Anode Removal and Replacement1. Using a 7mm wrench, remove the nut securing the anode.2. Unscrew and remove anode.3. Screw in the new anode and s

14Problem Possible Cause(s) Corrective ActionWATER LEAKS(See Leakage Checkpoints)Improperly sealed, hot or cold supply connection, relief valve or dra

15PARTS ILLUSTRATIONITEMNO.PARTS DESCRIPTION1ELEMENT GASKET2ANODE ROD3ELEMENT4HIGH LIMIT5TEMPERATURE SENSOR6THERMOSTAT7FRONT PANEL MOUNTING BRACKET8FR

16~ Certificate of Warranty ~See Rating Label Serial Number prefix for Warranty Code. Reduced warranty period applies to Newfoundland. Warranty Code:

2Your safety and the safety of others are very important.We have provided many important safety messages in this manual and on your appliance. Always

3INSTALLING YOUR WATER HEATERConsumer InformationThis water heater should be installed in accordance with the local code authority having jurisdiction

4Location RequirementsSite locationSelect a location near the point of use. It must be installed indoors and in a vertical position with water inlet a

5Electrical RequirementsThis water heater is equipped for one type voltage only. Check the rating plate on the side of the water heater for the correc

6Water System PipingPiping, fi ttings, and valves should be installed according to the installation drawing (Figure 4). If the indoor installation area

75. Install a shut off valve in the cold water inlet line. It should be located close to the water heater and be easily accessible. The owner/operato

83. When an uninterrupted stream of water, without appar-ent air bubbles, flows from the open hot water faucets, the tank is full.4. To purge the li

9OPERATING YOUR WATER HEATERBefore Using1. Make sure the water heater has been properly installed. See “Installing Your Water Heater” section.2. Com